Uno RFID Kit (V1)

$65.00 exc. GST

Item discontinued. Check out our Uno RFID Kit V2!

(This page is for archive and reference purposes only.)

Our Starters Arduino Kit is great for beginner makers.  The kit comes with an online guide which explores a range of technology concepts, ranging from beginner topics such as circuit design, motor control, and reading datasheets, to advanced topics such as RFID, stepper motor control, and inter-IC communications.

A general guide for this kit is available here.



Out of stock

SKU: URFIDKITV1 Category: Tags: , , ,


This Arduino RFID Starter Kit contains the following:

  • 16×2 LCD Display (LCD1602)
  • RFID Card reading module (MFRC522), with RFID Card and key chain,
  • Joystick module
  • 4×4 button board module
  • RTC module (DS1302)
  • Water level sensor
  • Temperature and Humidity sensor module (DHT11)
  • RGB LED module
  • Stepper motor (28BYJ-48), with motor driver module (ULN2003)
  • 1 Channel module
  • 800-pin breadboard (MB-102)
  • 65x jumper wire (Male-to-male)
  • 10x DuPont F-M cables
  • Sound sensor module
  • IR Remote
  • 10K potentiometer
  • 1x 7-segment display
  • 4x 7-segment digital
  • 8×8 LED matrix display
  • 9G servo motor
  • Buzzers
    • 1x ZLFY unsealed buzzer – datasheet
    • 1x potted sealed buzzer (washable, but keep sticker on when washing)
  • 2x tilt switch, ball type (AETHDX SW-520D) – datasheet
  • 3x photoresistors
  • 4x switches with coloured plastic caps
  • 9V battery connector with DC Barrel Jack
  • LED Pack, containing:
    • 5x 5mm Red LEDs
    • 5x 5mm Yellow LEDs
    • 5x 5mm Green LEDs
  • Resistor Pack, containing:
    • 10x 220R 5% tolerance.
    • 10x 1kR, 5% tolerance.
    • 10x 10kR, 5% tolerance.
  • Flame sensor
  • IR receive sensor
  • 8-Pin Shift Register (74HC595) – datasheet
  • Temperature Sensor (LM35DZ) – datasheet
  • Arduino-compatible Uno R3 board with USB cable
  • 40-pin snappable male header